Restore the slip-resistant effectiveness and pristine appearance your surfaces require. Daily cleaning and scrubbing can wear down the non-slip coating, often leaving the surface looking worn and discolored. Previously refinished surfaces can also be fully restored.

Our meticulous process includes deep cleaning, chip repair, and rust remediation—key steps to ensure guest safety and enhance appearance. Proprietary bonding adhesives and eco-friendly, odorless, and durable water-based industrial coatings—tinted onsite to match your tub color—set us apart from competitors.

Transform worn-out bathtubs to “like new” condition with our comprehensive refinishing service. Our skilled technicians follow a 10-step process to ensure the longest-lasting finish in the industry. Alongside expert preparation and proprietary bonding adhesives, we use eco-friendly, odorless, water-based industrial coatings, finishing with mold- and mildew-resistant caulk.

Eventually, caulk needs replacement, but you may not have the manpower to get it done. We can provide this service along with our Bottoms Only – Non-Skid Enhancement.

If the wrong caulk was previously applied, mold spots may appear, or if applied incorrectly, it can look uneven and lead to water damage. We use a siliconized acrylic latex adhesive for watertight protection, which cures to be mold- and mildew-resistant.

Unsightly blemishes, like black spots, will disappear. This repair is always included with our Bottoms Only – Non-Skid Enhancement service. While not all tubs have chips, we’ll repair each one as discovered.

The chip area is treated with bonding adhesive, filled with specialty putty, and sanded smooth. We then apply the same color-matched coating used on the bottom for a seamless finish.

Rust spots or stains affecting bathtub appearance can be eliminated. Over-tightening the screws on the overflow cover can crack the enamel, allowing water to reach the steel beneath, which then rusts.

If caught early, rust stains on the enamel are removed with high-strength cleaners. Severe rust, causing pitting or enamel flaking, is repaired with putty, sanded smooth, and refinished with a color-matched coating. This repair is also available with our Bottoms Only – Non-Skid Enhancement service.

More hotels are converting tubs to showers during renovations. The problem, however, is housekeeping often struggles to clean these surfaces thoroughly. It’s challenging to reach around the glass panel and scrub properly.

Instead, cleaning chemicals are sprayed on walls and floors; if not rinsed completely, residue dries and discolors the floor to a dirty yellow.

Solution:

1. Apply a non-acid detergent to loosen soap buildup and mineral deposits.
2. Mechanically deep-clean the shower pan with a high-torque handheld unit and scrubbing brushes to restore the original anti-slip surface.

This service can be performed in occupied rooms with immediate guest access—no downtime required.

This unique, cost-effective product can be applied to tile in lobbies, walkways, pool decks, dining areas, or any hard surface on your property to help prevent slips and falls. A single treatment leaves a micro-etched, nonskid surface that’s invisible to the naked eye.

The process increases the standard coefficient of friction (SCOF) by 0.6 to ensure stability and lasts up to two years with proper maintenance. Surfaces are ready for use immediately.